Uniden BEARCAT 880 Instrukcja Właściciela

Owner’s ManualPrinted in ChinaU01UT390ZZA(0)®880

10USING YOUR BEARCAT 880CB MODEBe sure that the power source, antenna, and microphone are properly connected before proceeding. BASIC SETTINGS1. Tur

11scanning in the selected direction.• To change to Memory Channel Scan mode, press MEM/SCAN while in All Channel Scan mode (see page 12).3. To exit

12Set Weather Alert ModeWeather Alert mode only operates when you are in CB mode; it does not operate in Weather mode. In CB mode, the radio sounds an

13MENUSAccess menus by pressing MENU/OK. The first menu, COLOR, displays. Turn the Channel Selector knob to cycle through the other menus:  COLOR - B

14Set LCD Contrast1. Press MENU/OK to activate the menus. Turn Channel Selector until CONT displays.2. Press MENU/OK. Turn Channel Selector until DA

15 – FAILHI - Voltage is too high.3. Press MENU/OK to return to the DIAG level.Antenna Mismatch CheckAn antenna mismatch indicates that reception qua

16the microphone to see the RF output power levels. Release PTT to see incoming signal strengh. Calibrate Standing Wave Ratio (SWR) Check and calibrat

17Use only the fuse specied for your Bearcat 880. Failure to do so may void your warranty. TROUBLESHOOTING In the event of system malfunction, perfor

18If you do not get satisfactory results after performing these checks, call the Uniden Customer Service Center at 1-800-297-1023, 8:00 a.m. to 5:00 p

19Hum and Noise: Better than 40 dBFrequency Tolerance: ±0.002%Modulation Percentage (Peak): 100%Spurious Rejection: -70 dBOutput Impedance: 50 ohm, u

CONTENTSSAFETY NOTICE ... 4UNPACKING ...

20not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for this product. STATEMENT OF REM

21RADIO CODE DEFINITIONS The following list contains common “10-Codes” used by CB radio operators for faster communication and better understanding. C

Code Meaning Code Meaning10-27 I am moving to channel 10-85 My address is 10-28 Identify your station 10-91 Talk closer to microphone 10-29 Time is

Uniden is a registered trademark of Uniden America Corporation.Bearcat is a registered trademark of Uniden America Corporation.Features, specications

4SAFETY NOTICEThe antenna used for this radio must be properly installed and maintained and must provide a separation distance of at least 34 cm (13.4

5Communications Commission (FCC). Any adjustments or alterations which would alter the performance of the transceiver's original FCC type accepta

6  Talkback: Talkback lets you monitor yourself when transmitting. Press Talkback to activate the function (LED = on). With Talkback active, press PT

711. MEM/SCAN: Press to start or stop scanning modes [All Channel Scan (see page 10) and Memory Scan (see page 12)]. Press and hold to set or clear c

8INSTALLATION MOBILE INSTALLATION Plan the location of the transceiver and microphone bracket before beginning installation. 1. Select a location th

9caution must be taken to prevent a short circuit. If in doubt, contact your vehicle dealer for information. Ground Information This transceiver may b