Uniden BEARCAT BC95XLT Instrukcja Użytkownika

BC95XLTBC95XLT

10IntroductionThis table lists the frequency ranges, default frequency step, default mode (AM or FM), and type of transmissions you can hear for each

11Feature HighlightsFeature HighlightsClose CallTM RF Capture Technology - you can set the scanner so it detects and provides information about nearby

12Feature Highlightsmarine, and weather banks, to make it easy to locate specific types of calls.Key Lock - lets you lock the scanner's keys to h

13Feature HighlightsAbout This ManualThe screen displays used in this manual are representations of what might appear when you use your scanner. Sinc

14Feature HighlightsTo get the most from this manual, review the contents to become familiar with the basic functions available. If you are new to sc

15Feature Highlightsfrequency, it stops on that frequency as long as the transmission lasts. If you think the frequency is interesting, you can progr

16Feature HighlightsGMRS/FRS radios. The range is typically 1-8 miles, depending upon the terrain and many other factors. Repeater OperationRepeater s

17Feature HighlightsYou can also call them at 1 800 SCANNER (hours are from 9:00 a.m. to 5:30 p.m. Eastern Time Monday through Friday).• http://www.ra

18Included With Your ScannerIncluded With Your ScannerIf any of these items are missing or damaged, immediately contact your place of purchase or Uni

19Setting Up Your ScannerThese guidelines will help you install and use your new scanner: • If your scanner receives interference or electrical noise,

2PrecautionsPrecautionsBefore you use this scanner, please read and observe the following. IMPORTANT!This scanning radio has been manufactured so tha

20Setting Up Your Scanner WARNING! Set REG. ALK. BATT./NI-MH BATT. to NI-MH BATT. only if you are using rechargeable batteries. Never attempt to re

21Setting Up Your ScannerCautions:• Use only fresh batteries of the required size and recommended type.• Always remove old or weak batteries. Batterie

22Setting Up Your Scannerthe scanner's DC 6V jack (see “Using AC Power” on Page 23). WARNING! Do not connect either adapter to the scanner if n

23Setting Up Your ScannerUsing AC PowerYou can power the scanner using the supplied 6V, 500 mA AC adapter.To use the scanner on AC power, plug the AC

24Setting Up Your Scannerexternal mobile antenna or outdoor base station antenna.Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable to connect an

25Setting Up Your ScannerThe Belt ClipTo make your scanner easier to carry when you are on the go, we provide a factory attached belt clip. Use a Phil

26About Your ScannerAbout Your ScannerWe use a few simple terms in this manual to explain the features of the scanner. Familiarize yourself with these

27About Your ScannerA Look At The KeypadYour scanner's keys have various functions labeled on the key tops and below the keys. To select the func

28About Your ScannerScan/Src Scan – Scans the stored channels.Func + Src – Starts chain search or resumes searching./ – Turns the display backlight

29About Your Scanner6/PSrc 6 – Enters a 6.Func + PSrc – Sets and turns program band select mode on or off.7 7 – Enters a 7.8/8 – Enters an 8.Func +

3Precautionsdamage if the volume suddenly becomes too loud because of the volume control or squelch control setting. This might be particularly true o

30About Your ScannerA Look At The DisplayThe display has indicators that show the scanner's current operating status. The display information hel

31About Your ScannerHOLD - appears during scan hold mode and search hold mode.L/O - appears when you manually select a channel you locked out or a ski

32About Your ScannerUnderstanding BanksService BanksThe scanner is preprogrammed with all the frequencies allocated to the weather, ham, marine, airc

33OperationOperationTurning On The Scanner and Setting SquelchNote: Make sure the scanner's antenna is connected before you turn it on.1. Turn

34Operation2 seconds after the end of a transmission before scanning proceeds to the next channel. To turn the function off or on, press Func + Dly.•

35Operationpress Func + or Func + to step through the frequencies.To release the hold and continue searching, press Hold. Or, if you did not press

36Operationtransmission, it stops on it. When the transmission ends, the scanner resumes scanning.Notes:• If you have not stored frequencies into any

37Special FeaturesSpecial FeaturesClose CallTM RF Capture TechnologyYour scanner's Close Call feature lets you set the scanner so it detects then

38Special Features• Close Call works better with some types of transmissions than others. It might not correctly display frequency information for tr

39Special Featuresbnd 800: 800MHz Band (806.0000 - 956.0000 MHz)If you selected C-C.Alt, skip to Step 5. If you selected C-C.PS, skip to Step 7.If you

4BC95XLT Controls and DisplayBC95XLT Controls and DisplaySquelchHeadphone JackSquelchVolumeBC95XLT Controls and DisplayDisplayKeypadDC 6VJackSerialPor

40Special FeaturesALt bP-Lt: The scanner flashes the display backlight and beeps when a Close Call signal is detected.ALt OFF: The scanner does not pr

41Special FeaturesUsing Close Call RF CaptureTo turn on the Close Call feature, press Func + C once except in WX search, band select, or program mode.

42Special FeaturesThe preset frequency ranges are:Chain Search ModePress Func + Src to start chain search mode. SRCH, the enabled search bank number,

43Special FeaturesTo start chain search hold mode, press Hold in chain search mode. The scanner stops searching and HOLD appears. In this mode, pressi

44Special FeaturesWhen you select the search bank, the lower limit and upper limit frequency assigned in the search bank alternate on the display.To s

45Special Featuresdirection upward. Frequencies appear during the search.Notes:• You can set the delay function on or off during the search or while t

46Special Features2. Press E to store the frequency into the blank channel. To select another channel, repeatedly press Func + or Func + to select

47Special Features1. Press Hold to stop the search.2. Press Func + or Func + to select the frequency. L/O appears.3. Press Func + L/O. L/O disapp

48Special Features• If the scanner is scanning and stops on an active channel where you want to store a delay, quickly press Func + Dly before it cont

49Special Features• You cannot turn off all banks. One bank must always be active.Locking Out ChannelsYou can increase the scanning speed by locking o

5ContentsContentsThe FCC Wants You To Know ... 7Scanning Legally ... 7Introduc

50Special Features1. Manually select the channel you want to select as the priority channel.2. Press Func + Pgm, then press Func + Pri. P appears to

51TroubleshootingTroubleshootingIf your BC95XLT is not performing properly, try the following steps. Problem Possible Cause SuggestionThe scanner does

52TroubleshootingScan won’t stop (continued)The antenna might need to be adjusted.Check the antenna connection.One or more channels might be locked ou

53TroubleshootingResetting the ScannerIf the scanner's display locks up or stops operating properly, you might need to reset the scanner.Caution:

54Care and MaintenanceCare and MaintenanceKeep the scanner dry. If it gets wet, wipe it dry immediately. Use and store the scanner only in normal tem

55Care and Maintenance• Clean the outside of the scanner with a mild detergent. • To prevent scratches, do not use abrasive cleaners or solvents. Be

56SpecificationsSpecificationsSpecificationsCertified in accordance with FCC Rules and Regulations Part 15, Subpart C, as of date of manu-facture. Ch

57SpecificationsSensitivity 12dB SINAD 25.005 MHz (AM) ... 0.5 µV 40.840 MHz (FM) ...

58SpecificationsIF Frequencies 1st IF (25-174 MHz)...380.6050-380.7000 MHz 1st IF (406-512 MHz) ...380.6125-380.7000 MHz 1st IF (806-956 MH

59Optional AccessoriesOptional AccessoriesContact your local Uniden Dealer or call the Uniden Parts Center at: (800)554-3988, 8:00AM to 5:00PM EST, Mo

6ContentsTurning Channel-Storage Banks On and Off ... 48Locking Out Channels ...

60One-Year Limited Warranty One-Year Limited War-rantyImportant: Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AME

61One-Year Limited WarrantyAND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERAT

62

63

© 2006 Uniden America Corporation, Fort Worth, Texas. Contains additional foreign articles. Printed in China.A World Without Wires®7,006,7977,006,7977

7The FCC Wants You To KnowThe FCC Wants You To KnowThis scanner has been tested and found to comply with the limits for a scanning receiver, pursuant

8The FCC Wants You To KnowHowever, there are some transmissions that you should never intentionally listen to. These include: • Telephone conversation

9IntroductionIntroductionThank you for purchasing a Uniden BC95XLT Handheld Scanner. The scanner is versatile, compact, and easy to use. In additio